FRIGOVENT air curtains for cold store doors and freezer rooms
THERMOVENT air curtains for service doors and factory gates

Assembly variants

Rear wall assembly with normal construction width

 

Rear wall assembly with normal construction width
The FRIGOVENT will be mounted with two stainless steel panels with solid polyamide blocks on the warm side of the wall above the door opening. This is the normal type of installation.


Rear wall assembly with reduction of the construction width

 

Rear wall assembly with reduction of the construction width
The FRIGOVENT will be mounted with two stainless steel brackets on the wall above the door opening.
These consoles take up less space in the construction width - but need more space in the height


Rear wall assembly with variable console distance

 

Rear wall assembly with variable console distance
The FRIGOVENT is mounted with two stainless steel brackets with solid polyamide blocks on the warm side of the wall above the door opening. If you can not mount the brackets in the right distance, it can be corrected by shifting the angle brackets below the polyamide blocks.


Ceiling mounting with mounting under the ceiling

 

Ceiling mounting with mounting under the ceiling
The FRIGOVENT will be mounted with two stainless steel brackets under the ceiling above the door opening.


Side mounting with mounting on the side walls

 

Side mounting with mounting on the side walls
The FRIGOVENT will be mounted with two stainless steel panels with polyamide solid plates on the side walls and in front of the door opening. This type of installation is often used in corridors that are sealed off by air curtains against cold air loss.